Object selection

It displays the length of the object.

LENGTHEN does not affect closed objects.

Total length: < current>, included angle: < current>

Select an object or [DElta/Percent/Total/DYnamic]: Select one object, enter an option, or press ENTER to end the command

Delta

It modifies the length of an object by a specified increment, measured from the endpoint that is closest to the selection point. Delta also changes the angle of an arc by a specified increment, measured from the endpoint that is closest to the selection point. A positive value extends the object; a negative value trims it.

Specify the different length or [Angle] < current>: Specify a distance, enter   A or press ENTER

Angle

It changes the included angle of the selected arc by the specified angle.

Specify the difference of angle < current>: Specify an angle or press ENTER

Select an object to lengthen: Object selection

The prompt will repeat until ENTER will be pressed to end the command.

Percent

It sets the length of an object by a specified percentage of its total length. Percent also changes the angle of an arc by a specified percentage of the total angle included in the arc.

Specify the percentage length < current>: Enter a positive (non-zero) value or press ENTER

Select an object to lengthen: Object selection

The prompt will repeat until ENTER will be pressed to end the command.

Total

It sets the length of a selected object by specifying the total absolute length from the fixed endpoint. Total also sets the included angle of a selected arc by a specified total angle.

Specify total length or [Angle] < current>: Enter a positive (non-zero) value or press Aor press ENTER

Total length

It lengthens the object to the specified value from the endpoint that is closest to the selection point.

Select an object to lengthen: Object selection

The prompt will repeat until ENTER will be pressed to end the command.

Angle

It sets the angle of the selected arc.

Specify total angle < current>: Specify an angle or press ENTER

Select an object to lengthen: Object selection

The prompt will repeat until ENTER will be pressed to end the command.

Dynamic

It activates the dynamic dragging mode, which is used to change the length of a selected object by dragging one of its endpoints. The other end remains fixed.

Select an object to lengthen: Object selection

The prompt will repeat until ENTER will be pressed to end the command.